eco3spa Step 1 Cold Tub Cleaner

eco3spa Step 1 Cold Tub Cleaner acts as both a plumbing and surface cleaner to remove scum, scale and biofilm from all surfaces leaving your tub hygienically clean and bacteria-free.

For cold tubs without a water circulation system…

1. Use eco 3 spa Step 1 Cold Tub Cleaner at each water change.
2. Empty the water and wipe all tub surfaces with a small amount cleaner on a soft, clean cloth.
3. Thoroughly rinse any cleaner residue away before the tub is refilled.

For cold tubs with a water circulation system…

1. Use eco3spa Step 1 Cold Tub Cleaner before each water change.
2. Ensure the tub is full of water to 50mm above all water inlets and outlets and remove the filter from its housing (if fitted).
3. Tip 100ml of Cold Tub Cleaner into the water for every 300litres of water in your cold tub.
4. Turn on the circulation for at least 60 minutes. It is normal for foaming to occur and dark coloured particulates to be seen.
5. Allow the water to stand for at least 30 minutes and then turn on the circulation again for a further 30 minutes.
6. Drain the cold tub. The drained water is safe to empty onto grass or plants.
7. As the water drains down wipe away any visible residue left on the shell of the tub and rinse the surfaces with fresh water.
8. Wipe away any stubborn scum marks by using a very small amount of the cleaner on a soft, clean cloth.
9. Rinse any cleaner residue away before the tub is refilled.